Forum topics

I have a Hitec HS805mg servo that I want to drive through 180 degrees with position control. I tried attaching to a 555 chip servo driver that position controls a smaller Dynan B2232 servo. It rotates through 180 degress but in between swings about, stop,s then makes random moves and continues on. It is never stationary.

I have purchased an 8 Channel 5V Solid State Relay Module Board.OMRON SSR 4 PIC ARM AVR DSP Arduino, from  www.sainsmart.com. I am wondering if there is a diagram to connect this up. On the output side, which terminal is NO and which is NC? There is a set of terminals for the 8 inputs and then a separate ground, does this need to be connected to the common ground from the power supply?

Check this: http://www.youtube.com/watch?v=U6g0iWuADL8

Techkriti is the annual Technological and Entrepreneurial festival of IIT Kanpur to be held from 14th to 17th March 2013.